Kenwood KA-7300 Amplifier

The build quality of these Trio/Kenwood KA-7300 amplifiers is absolutely superb. Chunky aluminium faceplate with heavy milled aluminium knobs and embossed lettering that cannot be worn off.

Six inputs, including two for your turntables. Excellent range of filters for tailoring your phono sound and multiple tone control adjustments for fine tone control. Four stage Loudness control for listening at lower volumes. Separable pre- and power-amp stages allow the superb pre-amp with fet-based phono amp to be used with more powerful power amps.

The power amp stages are a true dual-mono design, with individual transformers, power supplies and power amp boards for each side.

The amplifier power supply and power amp boards have been recapped using high quality, high temperature electrolytic capacitors, while smaller values have been replaced with film capacitors. The amplifier also has a new protection relay installed. All controls and switches have been cleaned and lubricated for smooth and silent operation.

This is a beautiful looking, beautiful sounding 1970s amp! You will be hard pressed to find another in such good condition.

Specs:
Power output: 65 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 40kHz
Total harmonic distortion: 0.04%
Damping factor: 50
Input sensitivity: 2.5mV (MM), 150mV (line)
Signal to noise ratio: 76dB (MM), 90dB (line)
Output: 150mV (line)
Dimensions: 430w x 149h x 376d mm
Weight: 14kg

$975
Six month warranty